Archives » December, 2016

Microbit Neopixel Christmas Tree

OK, so you’ve got your micro:bit RGB christmas tree from Andrew Gale’s kickstarter project. Its all soldered up ready to go as per his instructions but you’re not quite sure how to proceed. First, use some croc-clip wires to connect the pads on the christmas tree to the pads with holes on the micro:bit edge connector. It is […]

Read: Microbit Neopixel Christmas Tree

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close